BIO RAD 400-0174 Provozní pokyny Strana 310
- Strana / 485
- Tabulka s obsahem
- KNIHY
Hodnocené. / 5. Na základě hodnocení zákazníků
Maintenance - Engine
310
Pos: 26.14 /BA/ Wartung/Selbstf ahrer/Motor Big M 400/Motoröls tand @ 0\ mod_119677183 9187_78.doc @ 1 3329
13.4 Engine oil level
Caution!
The oil level is too low.
Effect: Engine damage
• It is absolutely essential for the life of the engine that you observe this
oil level.
• Check the oil level when the machine in at a horizontal position.
• Do not start the engine if the level is below the bottom mark of the oil
dipstick.
Fig. 278:
• Before pulling out the oil dip stick, its environment must be thoroughly wiped clean.
• The oil level must be between the min. and max. marks.
• After the oil level has been checked, reinsert the oil dipstick.
13.4.1 Engine oil and filter replacement
Note
For further information please refer to the engine manufacturer’s operating
instruction included with delivery (chapter on Engine oil and Filter
replacement)
Pos: 26.15 /BA/-----Seitenu mbruch------ @ 0\mod_119617 5311226_0. doc @ 4165
min.
max.
BMII-180
- Mower-Conditioner 1
- 1 Table of Contents 2
- Table of Contents 10
- Foreword 13
- 2 Foreword 13
- Introduction 14
- 3 Introduction 14
- 4 Safety 19
- Safety 20
- Safety 21
- Grund: gelb 23
- Schrift: schwarz 23
- Kreuz: rot 23
- Close valve when 27
- 1.2 bar 29
- BM 400 0181 30
- 12V / 24 V 31
- BM 400 0123 33
- BM 400 0182 34
- BM 400 0183 34
- BM 400 0001 35
- Cabin 36
- BX100280 39
- BM 400 0171 41
- BM 400 0016 43
- BX100210 45
- BX100213 45
- BX100212 46
- BM 400 0017 47
- BM 400 0187 49
- BM 400 0188 51
- BM 400 0192 55
- BM 400 0193 55
- BM 400 0145 57
- BM 400 0194 59
- BM 400 0146 60
- BMII-197 61
- BMII-196 62
- BM 400 0005 65
- BX 400 0006 66
- BM 400 0009 68
- BM 400 0012 72
- BM 400 0013 73
- BM 400 0014 74
- BM 400 0015 75
- BMII-200 89
- Cabin 91
- BM 400 0099 92
- BM 400 0100 93
- I 115:36 95
- changes to red 96
- BM 400 0116 97
- BM 400 0114 98
- BM 400 0105 98
- BM 400 0106 100
- BM 400 0103 100
- BM 400 0107 103
- BM 400 0108 104
- BM 400 0117 104
- BM4000109 105
- BM 400 0110 106
- BM 400 0104 108
- BM 400 0111 109
- BM 400 0032 110
- BM 400 0050 112
- BM 400 0051 113
- BM 400 0019 114
- BM 400 0021 115
- BM 400 0020 115
- BM 400 0033 116
- BM 400 0034 116
- BM 400 0112 119
- BM 400 0037 120
- = Metric (SI) units 121
- BM4000224 122
- BM4000225 123
- BM 400 0022 124
- BM 400 0023 124
- BM 400 0025 125
- BM 400 0024 125
- BM 400 0026 126
- BX500045 127
- BX500044 127
- BM 400 0027 128
- BX500046 128
- BM 400 0028 129
- BX500075 130
- = left mowing unit 133
- = front mowing unit 133
- = accept right mowing 133
- BM 400 0085 134
- BM 400 0038 137
- BM 400 0120 139
- BM 400 0121 140
- BM 400 0040 141
- BM 400 0039 141
- Actuator turned off 143
- Actuator turned on 143
- BM 400 0043 144
- BM 400 0042 144
- BM 400 0046 149
- BM 400 0052 149
- BM 400 0048 154
- BM 400 0054 157
- BM 400 0053 157
- BM 400 0058 162
- BM 400 0057 162
- BM 400 0062 168
- BM 400 0063 169
- BM 400 0064 171
- BM 400 0065 173
- BM 400 0067 177
- BM 400 0073 178
- BM 400 0068 179
- BM 400 0072 179
- = Cruise control inactive 181
- = Parking brake is applied 181
- BM 400 0069 185
- BM 400 0070 187
- BM 400 0074 188
- BM 400 0076 189
- BM 400 0075 189
- = Engine oil temperature 190
- BX500161 191
- BM 400 0079 191
- BX500190 192
- BM 400 0080 192
- Key not activated 193
- Key activated 193
- Broken cable 193
- Short circuit 193
- BM 400 0082 194
- BM 400 0081 194
- Key not activated 196
- Key activated 196
- = Current error 197
- = Fault storage 197
- key under the softkey 198
- key under the softkey 199
- A key under the softkey 200
- BX500126 201
- BM 400 0091 201
- BX500128 202
- BX500127 202
- BM 400 0092 203
- BM 400 0094 204
- BM 400 0095 204
- BM 400 0096 204
- BX500135 205
- BX500136 205
- -1.9 -1.8 206
- BM 400 0097 206
- BX500137 206
- BM 400 0113 207
- BM 400 122 208
- Commissioning 209
- 7 Commissioning 209
- BM 400 0148 213
- Start-up 214
- 8 Start-up 214
- Driving and Transport 216
- 9 Driving and Transport 216
- BM 400 0196 217
- BM 400 0007 219
- BMII-285 219
- BM 400 0010 220
- BMII-187 222
- BM 400 149 224
- BX100801 224
- BX100802 226
- BX500037 228
- BX500038 229
- BM 400 150 230
- BM 400 151 230
- BM 400 0008 232
- BMII-186 233
- Operation – Mowing Units 235
- 10 Operation – Mowing Units 235
- BMII-252 248
- BM 400 0147 250
- BX500036 255
- BX500035 255
- BM 400 0011 256
- Adjusting the mowing units 257
- BM 400 0175 258
- BM 400 0176 259
- BMII-189 263
- SFM05230 264
- BMII-372 268
- BMII-287 270
- BMS01030 276
- BMS01100 277
- BMS01071 278
- BMS01210 279
- BMS01270 280
- BMS01340 281
- BM301080 282
- BM300190 282
- BMII-276 284
- BMII-275 284
- BM 400 0160 285
- BM 400 0142 287
- Both augers on 288
- Right auger on 288
- Left auger on 288
- BMII-312 290
- BM 400 0161 291
- BMII-307 292
- BMII-308 293
- BM 400 0162 294
- BMII-311 295
- BMII-313 296
- BMII-314 298
- BMII-315 299
- BMII-320 300
- BMII-316 301
- BM 400 0163 302
- BMII-318 303
- BMII-319 305
- Maintenance - Engine 307
- 13 Maintenance - Engine 307
- BMII-180 310
- Maintenance – Mowing Units 318
- On request 322
- BMII-363 331
- EC-239-0min. 14 mm 337
- Maintenance – Basic Machine 349
- BMII-202 353
- BM 400 0165 358
- BMII-203 360
- BM 400 0166 362
- BM 400 0204 364
- BMII-215 367
- BMII-134 368
- BM 400 0205 370
- SFM1-510 372
- BM 400 0167 374
- BMII-365 378
- BMII-328 379
- BM 400 0212 380
- BM200551 382
- BMII-231 383
- BM 400 0144 388
- BM 400 0207 389
- BM 400 0208 390
- BX500088 391
- BiG M 400 Cab Circuit Board 393
- BX110007 395
- BX110008 395
- BX110009 396
- BX110010 396
- BX101960 399
- keys to select the 400
- Placing in Storage 402
- 19 Placing in Storage 402
- Error Messages 406
- Display fault 9 452
- Display fault 10 452
Související produkty a manuály pro Čtečky čárových kódů BIO RAD 400-0174
(25 stránky)© 2020, manymanuals.cz. Všechna práva vyhrazena. | 0.107 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Komentáře k této Příručce